Book Promo Banner
Yoke Inferfacing

Yoke Inferfacing

Home Page › Forums › Ask A Question › Yoke Inferfacing

Tagged: 

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • June 12, 2020 at 8:50 PM #88887
    Lemoncheeto
    Participant

    I bought the McCall’s L9411 today. I am stuck on the interfacing for the back yoke. The back yoke interfacing doesn’t show up on the instructions. However, it shows to cut 2 on the pattern. Am I missing something? I’m brand new to patterns. Help! 🙁

    June 15, 2020 at 10:43 AM #88952
    professorpincushion
    Participant

    hmmmm…that’s so weird. Is this a vintage pattern because I can’t find it on their site. So on the pattern piece of the back yoke, it tells you to cut two from interfacing? Or is it 1 from fabric, 1 from interfacing? If it’s an old pattern, it could be their graphics just decided to skip on showing it. If it’s a one for one (one fabric and one interfacing) I’d just go ahead an attach it. It’s not going to hurt anything, just make the yoke stiffer than without. I wouldn’t stress out about it too much 🙂

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • The forum ‘Ask A Question’ is closed to new topics and replies.